Turning Archive 2007

Subject:
Router sled used on lathe?

John Kyler
>I'm working on a new project where I need to true up 50 table bases on a lathe. I'm thinking of using a router on a sled. Anyone have any experience with or ideas. I will need to square up the base bottom and top, and also clean up a profile that looks like )( a big cove.
It starts at 16" dia. down to 3 in the middle and then back up to 16"(it is 25 inches tall.
John

Messages In This Thread

Router sled used on lathe?
Re: Router sled used on lathe?
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081