Turning Archive 2007

Subject:
Small problem, solution

Mike Nelson
>Top's off! I tried putting the box in the freezer, got a frozen box. Tried whacking it with a rubber hammer, no luck. Finally stuck it on the vacuum chuck and held a soft cloth to the top to heat it up. Must have expanded the top, came off with a small tap with the rubber hammer. I wonder if I took it right from the freezer to the lathe, it might have just lifted off? Thanks All, Mike

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081