Turning Archive 2007

Subject:
Vacuum Chucking

Dave Winters
>O.K. I'm finally ready to pull the trigger on a vacuum chucking system. I know this subject has been covered ad nauseum here and elsewhere, but I'm not sure my situation has been.
I'm an O.K. woodturner,but I don't have a lot of extra time to devote to plumbing and fabricating, etc.
So..does somebody sell an all inclusive "kit" to set me up, or do I have to buy everything ala carte?
Lathe is Oneway 2436, and I want a vacuum pump as opposed to a compressed air or shop vac system.
Thanks in advance.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081