Turning Archive 2007

Subject:
Speaking of un-square squares....

Mike Nelson
>I too use a center punch to 'square a square but I have a related problem with accuracy. I have several brands of tape measures, have adjusted all the tips and they are dead on out to a foot or so but when measuring out 4-6ft. or more they are almost an eighth of an inch different Does anybody know of a company that makes accurate tapes? Had the same problem with my self stick tape on my Powermatic table saw, ordered a new one and it was off too!

Messages In This Thread

Speaking of un-square squares....
Re: Speaking of un-square squares....
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081