Turning Archive 2007

Subject:
Undecided!!!!!!!

Barry Scotton.... on SaltSpring
>I want to do more end grain hollowing, vases etc up to 10 or 12 inches deep. I am torn between the oneway Termite and the Martel hook tool. Both seem to do the job, but throw into the mix the Hunter tool and the eliminator tool, both using carbide cutters. What do any of you use? What do you like or dislike about any of the above? Are there any others I should consider? All comments will be greatly appreciated.

Regards... Barry .... on SaltSpring

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081