Turning Archive 2007

Subject:
adapter questions

Robert Henderson
>I just got a new Jet mini lathe.
I have a bunch of 3/4"x16tpi faceplates and MT1 drives and collets and stuff that went with my old Craftsman lathe. I'd like to use that stuff rather than spend a couple of hundred dollars replacing it all.
Does anybody know -
Where I can get a 1"x8tpi to 3/4"x16tpi adapter?
Where I can get a MT2 to MT1 sleeve?
Do Morse taper adapter sleeves have a hole all the way through so I can thread a draw rod through it to use the collets?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081