Turning Archive 2007

Subject:
Wirebrushing?

Greg Haugen
>This may be a dumb question, it wouldn't be my first, but how do you "wirebrush" a piece?

Where do you find a good brush?

How far do you sand a piece before wirebrushing it?

Once the piece is where it needs to be is it just simply "brushed" with the grain??

Does the "brushing" create the final surface or does it then need be "steel wooled" to clean it up a little further? Any other words are there "fuzzies" that need to be cleaned up?

Sorry for the dumb question. But thanks for your time.

Greg Haugen

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081