Turning Archive 2007

Subject:
Three Point tool question

Barry Irby
>Is there an article on making a 3 point tool? I saw a recent post here on using one and it looked interesting. I also recall something about a making on that had a plumbing fitting hex nut for a ferral and by keeping the flats you could easily align it for sharpening. I have a table project coming up and there are beads on the legs. Seems like a good time to try out the 3 Point tool. Or Not. Maybe I should stick with what I know.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081