Turning Archive 2007

Subject:
quick 2-part grinder wheel question

Ted
>I just purchased a 6"x1" white Norton wheel from Lee Valley and it arrived with bushings that are only 5/8" wide. Is this normal, or should they be closer to 1" wide? Is this a big deal or not?

Secondly, when you dress a wheel, do you keep the corners square or round them over a bit?

Thanks,
Ted

Messages In This Thread

quick 2-part grinder wheel question
Re: quick 2-part grinder wheel question
Re: quick 2-part grinder wheel question
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081