Turning Archive 2007

Subject:
Tool Gloat *PIC*

RevDoug
>Somebody said the proof is in the picture. Well, I've talked about it a time to two, but have been too busy turning to take a picture yet. Well, I've not got 5 pieces turned on the new Nova 1624-44 and decided this morning to take a few pics. My only regret is that you can't see how deep the shavings are under the lathe.

Turn 'em round,

BTW, that's a 9.5" Maple burl bowl I turn for the LOML. It's only 1/2 was through the finish process. The Nova never even noticed it had the load on it. I love this lathe. 8)

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081