Turning Archive 2007

Subject:
Queestion: Mounting grinder wheels

Chuck Engstrom
>Hi folks -- I have new pair of grinder wheels. What is the trick to getting the opposite-threaded nuts on each with sufficient tightness? There's no excess shaft thread to play with, no flats on the inner portion of the shaft -- whatever I do to tighten one end loosens the other.

There must be an obvious trick to this that I need to be coached on.

Thanks--

Chuck Engstrom
Chestertown MD

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081