Turning Archive 2007

Subject:
PM 3520A Remote Switch Questions

Clem Wixted, Jonesboro, AR
>I am about to hook up a home brew remote on/off switch for my 3520A lathe.

First question is the routing of the wire from the head stock to the switch. I am thinking of routing it along the back side of the ways, around the end and below the tail stock and to the switch.

How is the factory switch wiring routed and how long is it?

What type of wire do they use? I am planning on using SJ 2-wire, 16 gauge.

Thanks,

Clem

Messages In This Thread

PM 3520A Remote Switch Questions
Re: PM 3520A Remote Switch Questions
Thanks, John
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081