Turning Archive 2006

Subject:
Inlace question on general message board

Joe Pack
>Turners, many of you have experience using Inlace or similar products. I posted a question about this on the general message board. If you have time, could you advise? I need to fill a 1/8" gap on all four sides of a project. Inlace sounds right, but I have never used it. Can you offer tips?

Details on the other page.

Joe

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081