Turning Archive 2006

Subject:
Love my shop heater..... *LINK*

Devon Palmer
>Hey,

I've seen a few posts around of people asking about shop heat. I have one of these and love it. I used this in my old shop where the temp would hang down between 40-50. I had it above the lathe out of the path of "most" of the chips, at an angle so they wouldn't collect, and I could easily work without a shirt due to the radiant nature of the heat. Much cheaper than gas (at todays rates) and no exposed flame. I blow it out before I turn it on each day.

Messages In This Thread

Love my shop heater..... *LINK*
Re: Love my shop heater.....
Re: Love my shop heater.....
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081