Turning Archive 2006

Subject:
Bit off more than I can chew

eliot d
>I've gotten to a place in my hollowing where I seem to want larger and flatter. Most recent one is about 10 inches wide and only 3 inches deep. The hole is about 1 1/8 inches in diameter. I'm over my head. I can't see any way to reach the outside from the inside. Clearly I could enlarge the opening, and I probably will. I have several constraining rigs and numerous swan neck tools including JJ, Denis Stewart, and some home made ones, but nothing that will reach far enough. If I wanted to be stubborn and keep going, are there any methods to do this kind of hollowing?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081