Turning Archive 2006

Subject:
Beal Buffing question

Dennis Taylor
>I have the Beal Buff, I use it now on smaller objects without a problem, mine is with the adpater to a motor shaft, problem is when I try to use it on platters or bowls, it isn't deep enough between the end of the shaft and the top the motor sits on, I have looked at the Packard site, and don't see any item to extend out the lenght, anyone else had this and combated it?...tks in advance...Dennis

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081