Turning Archive 2006

Subject:
Sharpening question

Mike Cunningham (Cape May NJ)
>A member of my club has a question, perhaps someone here as an answer.

He has Delta Sharpening Center with a white 200 grit vertical high speed stone and a wet 800 grit horizontal slow speed wheel.

He wonders if a commercially made jig for sharpening gouges is available or if one can be adapted for use with the wet horizontal wheel. Or, has anyone built such a jig and would share the info.

I'm a Tormek guy and while I've seen the Delta set up, have no knowledge of it's functionality, etc.

Thanks in advance!

Mike

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081