Turning Archive 2006

Subject:
oneway taper lock question

gary s clarke
>I have a spindle adaptor that is for the 2436 that goes from m33 to 1" 8thread so that I can use my vicmarc on the new lathe. Do I need to use a taper lock adaptor with the spindle adaptor? Also do I need a taper lock adaptor for a face plate? Oneway states that the taper lock adaptor is needed for their chucks to run true, so I have the adaptor for my stronghold chuck. thanks

Messages In This Thread

oneway taper lock question
Re: oneway taper lock question
Re: oneway taper lock question
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081