Turning Archive 2006

Subject:
Bill's lathe

Carol from AZ
>My friend Bill's lathe is a Delta Homecraft. He sent me an email. I did a little web searching. One reference to it was "a Model A of a lathe"! So what does the collective wisdom here know about a Delta Homecraft? Next week I hope to get by his place and take some pictures, measure his arm/hand to answer one of your questions, and see what I can see about the tailstock. Anything special I should be looking at/for?

I sure hope we can this working, for him (and for me!).

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081