Turning Archive 2006

Subject:
First Hollowing Rig, Pic 1 *PIC*

Allen Neighbors
>This was caused by that Red Elm. :o) I'd been planning on trying to build a deep hollowing rig for some time, but I had so much trouble with that Red Elm piece, I decided that it was now time.
This is made from 1" square tubing, and 1/2" allthread. I didn't do the welding.
I didn't make a block for between the ways, choosing instead to make a clamping device that goes across/under both sides of the Oneway ways.
This pic, taken before I installed the set screws, shows a 3/4" boring bar in the business end.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081