Turning Archive 2006

Subject:
Powermatic Interference problem solved

Mike Nelson
>Powermatic (WMH Tool Group) sent a EMI filter to 'test' on my 3520a. It works great! A couple of small problems, screw holes only line up on one side or other of inverter, top screws to lathe line up, bottom ones are off. It still connects solidly to the lathe. I have very little to no interference, unless I put the radio directly behind the lathe, I have it about 5ft to the right now and it works fine. We talked about this a while back and I thought PM owners (and Jet?) would like to know. The folks at WMH were very helpful with solving this, I delt with Rick', ext5868.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081