Turning Archive 2006

Subject:
Delta Midi newbie question

Steve Kubien
>My again,

Assuming I find out that turning is something I want to pursue (which I suspect it is), what are the thoughts and opinions on the Delta Midi lathe? The Borg around here just started carrying them and for $300 Cdn I can get the machine and a 5 piece starter tool set. Is this an ok deal? Is this lathe worth it or should I look toward the General Midi or the small Jet?

Thanks again,
Steve Kubien

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081