Turning Archive 2006

Subject:
Spindle Adaptor

Thad Parker
>Does anyone know where I could find an adaptor for converting a 5/8" shaft to 1" 8tpi (or other common thread)? Does such a thing exist or should I try to have something fabricated? I'd like to be able to use different faceplates and eventually chucks, but I cannot find anything that just fits on a 5/8" shaft with a set-screw, so an adaptor seems the logical thing to try. Any suggestions would be most appreciated.

~ Thad

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081