Turning Archive 2006

Subject:
Pen mandaral run out

alan womack
>I just replaced the rod in my manderal (woodcraft MT2) shaft. I was getting some difference at the nib end of my pens.

What is an acceptable run out at the nib end of a pen manderal?

The new one measures about .003+

Alan

Messages In This Thread

Pen mandaral run out
Re: Pen mandaral run out
Re: Pen mandaral run out
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081