Turning Archive 2006

Subject:
Veritas Scraper Burnisher for Woodturners

W.C. Turner
>Hi Everybody,

I finally got one of these burnishers, with the 2 rods, 1 ground at 10°, and the other rod ground at 5°

1) Does anyone know, if I would be correct in assuming, that the smallest rod is the 5° rod??

2) How close does one need to be to the 75°or 80° scraper bevel to burnish on the 5° rod, and/or, to the 70° or 75° bevel for the 10° rod? In other words, would you have to re-grind the scraper bevel if it doesn't fall into the 75°-80°, or 70°-80° category?

Hope that's clear as mud.

Thanks,
W.C.

Email: Remove 2

Messages In This Thread

Veritas Scraper Burnisher for Woodturners
Re: Veritas Scraper Burnisher for Woodturners
Re: Veritas Scraper Burnisher for Woodturners
Forgot...
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081