Turning Archive 2006

Subject:
Axminster-Enco ?

Mike Cunningham (Cape May NJ)
>I seem to recall a thread about a chuck, possibly a Bison, available at Enco that is the same as the Axminster 4" precision chuck but signifcantly less expensive. I want to add a chuck body to my Axminster collection. Does anyone know if my recollection is correct? If yes, do you know if it comes sized to specific spindles or is a threaded insert or backing plate required and finally do you know the item number?

I checked Enco online but can't locate the item.

Thanks in advance,
Mike

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081