Turning Archive 2006

Subject:
My "outboard rig" redux:with a much better picture *PIC*

steve antonucci
>So having returned from Disneyworld late last night (it was hot and crowded...) I set out to get in some shop time. I know that I confused some of you with my rig's hasty photography last week, so I took a much better shot today.

As you can see here, the upright is essential a deadman with a hole to accept the pipe. If I was going to do it over again, I'd probably use 2x6's for the base and 4x4's for the upright. It was hastily pieced together when I needed it, and might benefit from a redo, but it is manageable in it's current state.

Hope this answers any lingering questions.

Steve

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081