Turning Archive 2006

Subject:
Rule of thumb for drive center size?

K. Goring
>Is there a rule of thumb for the size of drive center one should use that is based on the length/diameter of the stock being turned?

Messages In This Thread

Rule of thumb for drive center size?
Re: Rule of thumb for drive center size?
Re: Rule of thumb for drive center size?
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081