Turning Archive 2006

Subject:
Maple Cherry Hollowform *PIC*

Barbara Gill, Remlik VA
>I have been trying to get these hollowforms right. I can see a flat spot on the top of this one now that it is off the lathe. If I were to do it over, I would round the top down a little more toward the shoulder. What about the rest? Comments please. 4"w x 3"t base 1 1/8"

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081