Turning Archive 2006

Subject:
clarify pm3520 adapter question

Mike Nelson
>I can't seem to find the answer to this. I want to go from my PM spindle,1 1/4"x8tpi down to a 1"x8tpi. I am trying to set up a vacuum chuck, have everything else ready to go but can't attach face plate. I could order a 1 1/4" face plate, but then couldn't use the ones I have that fit the delta mini lathe. Sorry about earlier post, it is a 1" 8tpi that I want to reduce to not 10tpi. any simpler ideas appreciated. Don't have a 1 1/4x8 tap. Thanks Mike

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081