Turning Archive 2006

Subject:
Buffing system comparison

DaveAnderson (Pac NW)
>It's been a while since I posted to the group. I went to the Doc for my semi-annual check-up, Passed with flying colours, and ended up with a 4-way bypass a week later. Anyway, I'm finaly back to my lathe. and I am looking a for a buffing setup. Could anybody tell me if the Oneway buffing system is any better or worse than the Beall system. I like the construction of the the Oneway wheel with the bound hub better than the loose sewn wheel of the Beall. Any information will be greatly apprecated (sp)
Thanks in advance,
Dave Anderson (PacNW)

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081