Turning Archive 2006

Subject:
Don't try this at home! *PIC*

Gary in Zirconia, NC
>This is my lathe (Demo lathe from Samson room) being loaded after the symposium was over. This is not the normal way Oneway loads lathes, but since my van was right outside the room the lathe was in and there happened to be a stack of cement blocks near by, Kevin just jacked the lathe up and slid it in.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081