Turning Archive 2006

Subject:
PM3520 wiring

Spence in Rhode Island
>Getting ready to run the wires for the new lathe. Which would be better nm12-3 w/ground or nm10-3 w/ground? Also 15 amp or 20 amp circuit breaker? I'm also putting the Rikon 18" bandsaw on the same circuit since only one machine will be used at a time. I know that's not really the correct way to do it but space is limited in the pannel and after paying for the two machines money is in short supply also. ;) So whats the best way to go here?
Thanks
Spence

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081