Turning Archive 2006

Subject:
P&N Gouges?

Bill Grumbine (Kutztown PA)
>Greetings all

Earlier in the week, the tang on my spindle roughing gouge snapped like a fresh potato chip. I was even turning a spindle! Anyway, I am looking at replacing it with a P&N gouge. I was wondering if anyone here had any experience with them. Since I will be at a fairly large show next week, I will hold out until then to see if anyone might be selling them there. ;-)

Bill

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081