Turning Archive 2006

Subject:
update on Lathe woe

John Veerkamp
>I need to set the record straight. To my surprise, for all of their seeming lack of concern, Delta service center did replace the controller for my 745 lathe. The controller is the one now used on the 755. It requires 220 input instead of 110 but this is not a problem since my lathe outlet is 3" from my pannel. My faith in this company is somewhat restored.
Turning again,
John

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081