Turning Archive 2006

Subject:
Any Segmented Turners using incras?

dick mc neill
>Do any segmented turners use an incra miter gauge in lieu of the home made miter sled or chop saw? If so any comments? I'm interested in using the model 3000 on my table saw for segment cutting & on my disc sander for small pieces in a featured ring. Also does anyone use the Jolly Jig as a stop for segments? Thanks in advance.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081