Turning Archive 2006

Subject:
RIDGID Bandsaw Riser Block??????

Greg H. from Wisconsin
>I have a 14" RIDGID bandsaw, the casting looks the same as a Jet or Delta. Would either a Jet Or Delta's riser block kits fit this saw. Has anyone done this before or have you found the RIDGID riser kits. I'm a bowlturner, I would like to think so at least, and the 6" limit is fine but I would be nice to have a 6 1/2" bowl blank go through the saw without a chisel or chainsawing it again.

Thanks
Greg

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081