Turning Archive 2006

Subject:
Tried Something New With A Slimline *LINK*

George (Oxford, NC)
>May not be new but at least its a new style for me. I cut the upper blank length to (standard length + thickness of centerband + "), used a tube that was standard length + thinkness of centerband. Drilled out the " with a bit the same diameter as the 7mm bushings OD. Turned the lower blank BtoB so the " hollow in the upper tube would overlap the lower tube. Material is cedar.

George

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081