Turning Archive 2006

Subject:
Tip for newbies *PIC*

Carole Valentine
>Intended to post this a long time ago when I was asked how I reversed chucked hollow forms, but never got around to it. When I was first starting hollow forms I often had problems with them spinning as I tried to finish off the bottom after reverse chucking them. This is my method now and I never have a problem. The material is the rubber drawer liner/router mat stuff. I got an 8' roll of it at Sears I think. Just cut an appropriately sized square, cut a small X in the center and slip it over the cone. Guaranteed to eliminate slippage.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081