Turning Archive 2006

Subject:
Basket weave closed form

Jens Bingel
>I would like to test my patience and turn/carve a basket following J.Paul Fennell's tutorial. My question is if a reciprocating carving kit for my Dremel is adequate and if so what bit to buy and where to square the little holes. J. Paul Fennell mentioned a bit No. 165L in a dental catalog, but I have not found the catalog.

Any advice will be greatly appreciated.

Jens

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081