Turning Archive 2006
>I decided to balance my grinder wheels with the one way system.
What a pain!!!
Does this system only work on new wheels?
When it says to use Right Hand thread appliance, does this mean the wheel who's nut tightens to the right.?
If when removing the wheel, I get it turned around and put the weights on the face of the wheels that was on the inside when on the grinder, did I blow it.
This is a slow speed grinder 1"X 8" X 5/8 shaft.
It runs worse now then when I started.
This is all my fault I am sure, but as usual, one ways directions SUCK
Any help appreciated. Joaz