Turning Archive 2006

Subject:
Another Powermatic Question(s)

Clem Wixted
>I had a machine shop cut a few pieces of 1 inch cold rolled steel to be used as posts for some shop made tool rests.

The 1 inch doesn't fit into the banjo. It is a tad large.

Two part question:

1. Is the hole in the banjo a metric size?

2. Can I ream out the banjo to receive the 1 inch crs?

Thanks,

Clem

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081