Turning Archive 2006

Subject:
Making tools

Don Tewell
>OK I need some help. I am going to attempt to make a couple of tools. How deep should the steel go into the handle? I will probably use some kind of epoxy but don't know how deep to place the chisel. TIA for all the help I know I'll get.

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081