Turning Archive 2006

Subject:
BLM Burl Hollow Form

Dick Hines
>I posted the question earlier about maybe drilling a small hole in the bottom of hollow forms so the pressure could be the smae in side and out. After I finished the hollow form in question I have decided I will not have to do anything like that. I think it is thin enough that it will breath.

I just got back from the post office where I had if put on a set of regestered scales. Would you beleave 8.7 oz.? It stands 7" H X 6 1/4 D. I will try to post a picture next.

Messages In This Thread

BLM Burl Hollow Form
Where's the pic, Dick?! *NM*
Carole is a poet *NM*
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081