Turning Archive 2006

Subject:
Now you've gone and done it PM3520

Bob Fawcett
>I pulled the trigger and ordered a PM3520 today. It should be here next week.
I need to wire the shop for the 220v feed to the lathe. Can anyone tell me the circuit size requirement? I can't find anything in the manual or on PMs web site. It has the 2HP motor and inverter drive. I am guessing it needs a 30 Amp circuit, but can't confirm it. 10/2 with a ground or 10/3 with ground?
Did you wire yours with a plug, or a local disconnect?

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081