Turning Archive 2006

Subject:
Loose lid on a box

adrien
>One minute the lid's too tight, a light (?) touch with the gouge or skew and now it's too loose.

I ran a bead of thin super glue all around the outer edge of the spigot that fits into the lid. Held it upside down to avoid creating a fillet. Let it harden without an accelerator.

With fingers crossed that it had fully dried, put the cap on. A neat fit. And since the glue had set the cap came off with no trouble.....

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081