Turning Archive 2006
>Russ I pulled out my old paddle wheel sanding discs to give them a try again after your post last week. I don't know what I did differently than the last time I used them but I didn't have any trouble and was able to sand out the chatter marks on the inside of box. I was getting some chatter no matter how sharp my tools were and how careful I was, even holding the outside with my hands. I got rid of 90 pecent of the bad places with a good sharp bowl gouge but right near the lip was fighting me no mater what.
One of my wheels is 120 grit the other is finer but not marked. I cleaned it right up with these. Thanks for getting me back in the groove with them.
Messages In This Thread
- paddle wheels