Turning Archive 2006

Subject:
Chatter tool work ......

GordonP in Sumner, WA
>I don't do much turning, but wondered if you can use a chatter tool on small spindles and pens??

found a great site yesterday - it was on the standard messageboard and they stream videos 24/7 of many wwking shows. I watched one on chatter tool work, which was very interesting - thus my question??

reply via email would be best, but I will check back tomorrow or later today if I get the oppty

Messages In This Thread

Chatter tool work ......
Re: Chatter tool work ......
Re: Chatter tool work ...... *PIC*
endgrain....
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081