Turning Archive 2006

Subject:
Help with morse taper slipping

Bruce
>I am having a problem with the taper slipping on my chuck as well as my buffing system. I have tried to gently tap the chuck in but it seems to begin slipping rather easily. I have cleaned the inside of the spindle and the tapers with no luck. This never seemed to be a problem on my jet mini but it has been a challenge on the new powermatic. I hope my terminology is close enough for you to understand my problem.

By the way, this is an awesome group of folks with more talent than should be allowed.

Thanks,
Bruce

© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081