Turning Archive 2006

Subject:
My new Lathe *PIC*

Wayne Kuhn
>here is my new set-up.
Grizzly G0462. Along with my grinder, buffing set-up and $45 Penn State chuck. The grinder & buffer get moved to my bench 2 steps away wilst I'm turning.
I got the griz in late January and have ben giving it a workout.
Yesterday I Turned a 27lb, 12" rnd x 7" thick hunk of hickory (acording to my neighbor, but I believe it is poplar)on a 3" faceplate fron Don Pencil. This has been my largest piece to date. I was little worried but it did not skip a beat. Yes the lathe is bolted to the floor. I Was working on the inside when I noticed ring/wind shake. oh well, on to the next piece. Just thought I would share my Joy.

Messages In This Thread

My new Lathe *PIC*
Re: My new Lathe
Re: My new Lathe
Re: My new Lathe
© 1998 - 2017 by Ellis Walentine. All rights reserved.
No parts of this web site may be reproduced in any form or by
any means without the written permission of the publisher.

WOODCENTRAL, P.O. BOX 493, SPRINGTOWN, PA 18081